Communicating with the R325PE
Step 1: Move all dipswitches to the OFF position. Place jumper on Pins 1 & 2.
Inage 6.3
1. Connect P1 to PC via RS485-232 Converter Card or USB485 Converter Card.
2. Set up HyperTerminal by selecting correct COM port
3. Settings for HyperTerminal is as follows: 57600, 8 bits, None, 1, None
4. The R325P Driver only version allows for changing the hold timeout settings, the amount of mixed
decay, and to check the firmware revision level.
RS485-232 Converter Card
Figure 6.2
dipswitches
to the OFF
placed
closest to
the LED.
RMS Technologies Page 12 Version 1.01
R325PE Single Axis Closed loop Driver/Indexer Manual 5/29/2013
Comments to this Manuals